last one

To finish the guitar, we first installed the strings over our pre-set bridge saddles. we put them thouh the string farals and we used a string winder to wind them up. Then, we set string hight at the 12th freat by aujsting the saddles . then we set the hight at the 1st fret by filing down the nut slots. Finally, we we set the 12th string sounds like the open string. we used an electronic tuner to check.

we did freat spaceing and the sprend sheet. the spread sheet calculated the right number for the spcaein for the frets and all we had to do was enter the scail length for the gutar. For our guitars, the at was 25.5″.

if i coud i would take this class one more time so i can have fun with it one more time for all sudedens if yoju take this class then you sould it is the most fun you have ever had well thats for my class i hope if any one reads this it helps them get a undersandig for this once in life time cane then take this class . well have a nice day by dustin blake.

week 23

well my frend ben shoud me some streing on the gutar so i can stop playing omic donaled had a farm so yep new songs on the way

21 week

straunge up my gutar and for the tools i used was a turner and a finger

week 15

frist things frist sorry for not doing this blog

i used a froues uner bit and the corded drill with it

week 20

redoing wireing is a pain so dont mess it up like me i leard that you need to look at the blue praint and to look at the wirers and the tool i use the sater gun and sater du

week 19

i am a paieiney working on my gutar

string holder and the strap monts

week 17

**we did a dip paint and we relay did the nick i messt it up so we had to redo it**

**tools used a buckit and a water and paint**

week14

This week, I drilled a hole for the output jack on the project guitar. This hole is located on the bottom right side of the guitar and passes into the electronics control cavity. The tools I used were a 7/8 forstner bit and a drill.

I learned that i have to push on the bit to get it to pass through the hard maple. I also worked on my test and we talked about the wiring of our guitars and how the signal goes to one point from the other point. I learned with continuity that it is not directional does not matter which way the signal goes.